Chapter 5
Novell NetWare Installation
46
Installing the Driver When NetWare is Already
Installed
To update or install the
<File Name>
adpt160m.ham driver when NetWare is
already installed, follow the instructions in this section. The procedures are similar
for all versions of NetWare. Procedures that are specific to a NetWare version are
noted when necessary.
1. Make a backup copy of the old driver (if it exists) before installing the new
driver.
2. Copy the
<File Name>
adpt160m.ham driver from the HP Ultra3 Family
Manager Set disk for NetWare into the server’s startup directory (e.g.,
c:\nwserver, c:\server.40) on your hard disk. This overwrites any existing
version of the driver in the directory.
3. If necessary, modify the load command line in the startup.ncf file so that the
proper path to the driver and all appropriate command line options are specified.
See
“Loading the Driver at Server Bootup”
on page 46.
The correct syntax to load the Ultra3 Family driver is:
load [
pathname
]adpt160m [
options
]
Command line options are
not
case sensitive. Placing commas between command
line options is optional. See
“Loading the Driver at Server Bootup”
on page 46 for
possible values.
Loading the Driver at Server Bootup
To automatically load the
<File Name>
adpt160m.ham at server bootup, the
startup.ncf file (usually located in your server’s startup directory) must contain a
load command line that specifies the location of the driver and any appropriate
command line options (see
“Using the Load Command Line Options”
on page 47).
For additional information on the startup.ncf file, refer to your NetWare
documentation.
The correct syntax to load the driver is:
NOTE
For NetWare 3.12/3.2 and 4.12/4.2, the file is in \netware. For
NetWare 5.0, the file is in \netware\v5_xx.
Summary of Contents for P3413A
Page 6: ...vi Contents ...
Page 64: ...Chapter 5 Novell NetWare Installation 58 ...
Page 66: ...Chapter 6 Linux Support 60 ...
Page 70: ...Appendix A Product Specifications 64 ...
