Hardware options installation 71
Installing an expansion board
When installing a high-wattage video/graphics controller, observe the following guidelines:
•
Install the controller in the x16 slot ("
System board components
" on page
11
).
•
Install the 150W PCIe video/graphics controller power cable ("
150W PCIe video/graphics controller
power cable option
" on page
82
).
CAUTION:
To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the expansion boards.
To install the component:
1.
Power down the server (on page
24
).
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
Open or remove the tower bezel
" on page
25
).
o
Extend the server from the rack (on page
24
).
3.
Remove the access panel (on page
26
).
4.
Remove the expansion slot cover from the slot, if installed ("
Removing the expansion slot cover
" on page
70
).
IMPORTANT:
It may be necessary to remove the slot cover next to the slot in which you are
installing a board.
5.
Install the expansion board.
6.
Close the expansion slot latch to secure the board.
7.
Connect any required internal cables to the expansion board. Refer to the documentation that ships with
the expansion board.
8.
Close the expansion board retainer.
9.
Install the access panel (on page
27
).
10.
Do one of the following:
Summary of Contents for ML350 - ProLiant - G2
Page 89: ...Hardware options installation 89 c Slide them back and away from the chassis ...
Page 112: ...Troubleshooting 112 ...
Page 137: ...Technical support 137 ...
Page 138: ...Technical support 138 ...
