Hardware options installation 63
Removable media device options
Identifying guide screws
When installing drives in the removable media bay, guide screws must be installed to make sure the drives
align correctly in the drive cage. HP has provided extra guide screws, 5.25 M3 metric screws and/or HD
6-32 shipping screws, located behind the media bay blank. The metric screws are black.
Installing a half-height or full-height media device
The server includes five removable media bays. The server ships with an optical drive, and the other four
bays have blanks. You can install two full-height devices or up to four additional half-height media devices in
the removable media cage.
To install a half-height or full-height media device:
1.
Power down the server (on page
24
).
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
Open or remove the tower bezel
" on page
25
).
o
Extend the server from the rack (on page
24
).
3.
Remove the access panel (on page
26
).
4.
Remove the media bay blank (on page
27
).
5.
Install the guide screws ("
Identifying guide screws
" on page
63
), if applicable.
6.
Slide the drive about three-fourths of the way into the bay, leaving room to connect cables at the back
of the drive.
o
Half-height device
Summary of Contents for ML350 - ProLiant - G2
Page 89: ...Hardware options installation 89 c Slide them back and away from the chassis ...
Page 112: ...Troubleshooting 112 ...
Page 137: ...Technical support 137 ...
Page 138: ...Technical support 138 ...
