HP J2962A, Installation And Reference Manual

Page: 15 / 36

5. Repeat step 1 through 4 for each device to receive redundant power.
With four devices connected to the RPS, your rack would appear
similar to the following illustration:
3. Verify the RPS’s Operation
To verify the operation of the RPS, follow these steps:
1. Connect both of the included RPS AC power cords from the
RPS AC Power connector to a reliable AC power source. HP
recommends two separate AC power lines for added redundancy.
2. Check the LEDs on the RPS’s front panel:
During Power-On: All LEDs are on for one second.
After Power-On: AC Power LEDs are on.
Connected DC Power Output LEDs are on.
Fan is on.
If the Fault LED is on, see the troubleshooting table on page 12.
Hub-24
Hub-24
Hub-48
Hub-48
RPS
RPS AC power cords connected to an
operating AC power source
Installation Summary
9