The Membership column shows the ports that compose the link
aggregate.
If the link aggregate contains ports that you do not want in the
aggregate, delete the ports by issuing the following command:
# nwmgr -d -A links=port-number -c lanxxx
where
port-number
can be a list of multiple ports numbers separated
by commas and
xxx
is the instance number of the link aggregate (for
example, 900).
If any ports you wanted in the link aggregate are members of another
link aggregate, delete the ports in the other aggregate by issuing the
following command:
# nwmgr -d -A links=port-number -c aggregate-instance
If there are ports you wanted in the link aggregate that are not members
of the link aggregate, do the following:
1.
If FEC or LACP is enabled on the port, stop autonegotiation with
the following command:
# netmgr -s -A mode=MANUAL -c lanxxx -S apa
where
xxx
is the instance number for the port.
2.
Verify the type, speed (including duplex), and MTU size of each
port you want with the following command:
# nwmgr -v -c lanxxx
All ports must have the same values. If they do not, make any
changes as necessary on the server and the switch.
3.
Check if there is an IP address or a VLAN on the port.
All ports active?
NO
YES
Verify the active ports in the link aggregate by issuing the following
command:
# nwmgr -v -c lanxxx
where
xxx
is the link aggregate instance number.
The Active Port(s) field lists the active ports.
If there are ports in the Not Ready Port(s) field, verify the port's
operation status by issuing the following command:
# nwmgr --st -c lanxxx
where
xxx
is the interface number.
If the Operation Status is UP, check the speed (including duplex) and
MTU for the port and another active port in the link aggregate with
the following command:
# nwmgr -A speed, mtu -c lanxxx
If they do not match, correct the settings on the server and the switch.
See the steps for
Link partner configured?
. If they match, reset
the port.
If the status is DOWN, check the cabling from the NIC to the switch
and see the steps for
NIC operating?
.
On the switch, verify that all ports you expect to be in the link aggregate
are in the same MANUAL trunk.
Solving HP APA problems
61
