2 Installing the APA software
This chapter describes the information required in order to install APA on your system.
Installation requirements
1.
Log in to the HP-UX server as superuser.
2.
Confirm that the
/usr/bin
,
/usr/sbin
, and
/sbin
directories are in your PATH by using
the
echo $PATH
command.
3.
Use the
uname -a
command to determine the HP-UX version of your system.
Product dependencies
See the HP-UX Auto Port Aggregation (APA) Release Notes for required patches and known problems
and workarounds.
IMPORTANT:
You must install the required patches before you install the HP APA software.
Hardware requirements
Supported switches
HP APA supports the Cisco FastEtherChannel (PAgP) protocol, the Link Aggregation Control
Protocol (LACP) (IEEE 802.3ad), and manual trunking mechanisms. HP has tested switches from
the following vendors to work with HP APA:
•
3Com
•
Cisco
•
HP Procurve
•
Foundry
•
Alteon
•
Nortel
•
Extreme
HP APA also supports Nortel's Split Multi-Link Trunking (SMLT) technology. Specifically, HP
has tested the Passport 8006 and Passport 8010 switches with the version 3.7.13.0 of the software.
Supported LAN cards
The following network interface cards are supported:
•
All HP PCI 10/100Base cards (both FX and TX)
NOTE:
HP APA does not support the 10/100 BT Standard/Management LAN interface
found on some systems and controlled by the
intl100
driver, and any other devices
controlled by the
intl100
driver.
•
All HP PCI 1000Base cards (both Base-T and SX)
•
All HP PCI-X 2-port Combination cards (network ports only)
•
PCI-X 10 GbE Fiber cards
•
Infiniband IPoIB cards (failover groups only) (December 2008 release of HP APA for HP-UX
11i v3 (B.11.31.30) and later)
Installation requirements
17
