91
Card Power
consumption
Net weight
Dimensions (H
×
W
×
D)
LST1GT48LEB1
110 W to 175 W
4.25 kg (9.37 lb)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
LST1GT48LEC1
115 W to 190 W
4.44 kg (9.79 lb)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
LST1FW2A1
90 W to 120 W
4.36 kg (9.61 lb)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
LST1FW3A1
128 W to 168 W
4.80 kg (10.58 lb)
40 × 400 × 467 mm (1.57 ×
15.75 × 18.39 in)
For more information about the 12500E cards, see the relevant datasheet of the cards.
MPUs
CAUTION:
•
HP recommends that you install two MPUs on a switch for redundancy. If two MPUs are installed, their
model must be the same. Otherwise, the standby MPU cannot start up.
•
The USB ports on the MPU can be used only to connect to storage media such as USB disk, and cannot
be used to charge external equipment. Otherwise, the MPU might fail.
•
The length of the USB cable used for the LST1MRPNE1 must be less than 4 m (13.12 ft).
Table 28
MPU specifications
Item Specifications
Model
LST2MRPNC1 LST1MRPNE1
Flash
128 MB
512 MB
BootWare
4 MB
8 MB
NVRAM
1 MB
1 MB
SDRAM
4 GB
8 GB
CF card
1 GB
4 GB
Interfaces
•
1 console port
•
1 AUX port
•
1 network management port
•
1 CF card slot
•
2 USB ports—HOST and DEV (DEV is not
supported)
•
2 MCC GE ports
•
1 console port
•
1 USB console port
•
1 network management port
•
1 ECP port (reserved)
•
1 CF card slot
•
1 USB ports
•
2 MCC GE ports
NOTE:
The MCC GE port is supported only in Release 73xx or later.
Switching fabric modules
IMPORTANT:
Use the switching fabric modules of the same model on a 12500E.
