9.
Release the ZIF connector to which the power button board cable
(4)
is connector and disconnect
the cable from the system board.
10.
Remove the Phillips PM2.5×6.5 screw
(1)
from the top cover, disengage the rear edge of the top
cover
(2)
from the base enclosure, and then remove the cover from the computer
(3)
.
Reverse this procedure to install the switch cover.
60
Chapter 4 Removal and replacement procedures
Summary of Contents for COMPAQ PRESARIO G42
Page 4: ...iv Safety warning notice ...
Page 143: ......