Service Reference Guide, d200
336493-004
6–21
Removal and Replacement Procedures— Microtower Type 2 Chassis
6.13 Processor and Heatsink
1. Prepare the computer for disassembly (
Section 6.1, “Preparation for Disassembly”
).
2. Remove the right access panels (
Section 6.2, “Access Panel”
).
3. Lay the computer down on its side to make it easier to work on.
4. Remove the J-shaped air baffle
if applicable
(
Section 6.11, “Air Baffle”
).
5. Disconnect the fan control cable from the system board.
6. Use a long, slender screwdriver to unscrew the four processor retaining screws
1
.
✎
The spring-loaded retaining screws are captive to the heatsink.
7. Twist the heatsink to break the bond between it and the processor and lift the heatsink from
the processor
2
.
8. Raise the handle on the ZIF socket to the full-open position
3
.
9. Grasp the processor by the edges and pull it straight up from the socket
4
.
To install the processor and heatsink, reverse the removal procedures making sure that you hold
the processor in place while locking the ZIF socket handle.
Ä
CAUTION:
When installing the heatsink, insert all four screw loosely and then tighten them in a X
pattern to ensure the heatsink is properly seated.
Summary of Contents for Compaq d220 MT
