6–22
336493-004
Service Reference Guide, d200
Removal and Replacement Procedures— Microtower Type 2 Chassis
6.14 System Board
1. Prepare the computer for disassembly (
Section 6.1, “Preparation for Disassembly”
).
2. Remove both the right and left access panels (
Section 6.2, “Access Panel”
).
3. Remove the front bezel (
Section 6.3, “Front Bezel”)
.
4. Remove the diskette drive (
Section 6.7.3, “Removing a Diskette Drive”
).
5. Disconnect the power, and data cables from the back of all installed 3.5" drives.
6. Remove the lower drive cage (
Section 6.7.4, “Removing the Lower Drive Cage”
).
7. Remove the J-shaped air baffle if applicable (
Section 6.11, “Air Baffle”
).
✎
It is not necessary to remove the fixed portion of the air baffle from the chassis.
8. Disconnect all cables from the system board.
9. Remove the heatsink from the system board (
Section 6.13, “Processor and Heatsink”
).
10. Remove the 8 screws that secure the system board to the chassis
1
.
11. Slide the system board towards the front of the chassis
2
to remove it.
To install the system board, reverse the removal procedure.
✎
The system board shown may be different from the one installed in your computer.
Summary of Contents for Compaq d220 MT
