Replacing Autoloader Parts
Returning the Autoloader
Chapter 3
3-9
Rep
lac
ing
Pa
rts
5. To prevent damage, lock the transport by running the
Lock Transport
front panel test.
Figure 3-4
Removing the Front Magazine
NOTE
Be sure to also remove the tapes from the internal back magazine.
CAUTION
Do not power-off the autoloader until the interface is inactive. Removing
power from a SCSI peripheral when the bus is active can result in data
loss and/or indeterminate bus states. If your computer is connected to a
LAN, be sure to check with your system administrator before powering-
off.
6. Power-off the autoloader. The power “standby” switch is recessed to
avoid accidental power cycles. Disconnect the power cable.
7. Remove the drive module by following the procedures in “Removing
the Drive Module” on page 3-4.
8. Remove and keep all external cords, cables, and terminators.
Summary of Contents for C7745NB - SureStore DLT Tape Autoloader 1/9
