HP C7745NB - SureStore DLT Tape Autoloader 1/9, Manual

Page: 15 / 63

Overview and Preparation for Upgrade
Removing a Rackmounted Autoloader (if necessary)
Chapter 1 1-5
Ov
erv
iew
& P
rep
ara
tion
ADVERTENCIA
Antes de empezar, baje las patas de nivelación del bastidor y abra el
dispositivo estabilizador del mismo. En caso de no abrir el dispositivo
estabilizador, existe el peligro de que se produzcan lesiones personales
o daños al cargador automático de cintas si se vuelca el bastidor.
Removing the Autoloader from a Rack
To remove the autoloader from a rack, do the following:
1. Release the filler panel (and/or trim bracket) from the spacer bracket
by releasing the screws from the clip nuts located at the front of the
autoloader (see Figure 1-2).
2. Using two people or an appropriately rated lift, remove the
autoloader by gently sliding it toward the front of the rack.
3. Place the autoloader on a stable surface in preparation for upgrade.
Figure 1-2 Removing the Autoloader