Setup and Installation Guide
www.hp.com
4-19
Installing and Cabling the HP CCI Solution
Powering Up the HP CCI Solution
As soon as you connect an AC power cord to a hot-plug power supply
on the rear panel, the enclosure powers up. All Blade PCs already
installed in the enclosure also power up one at a time in
approximately one-second intervals. Plug in the second power supply
for redundancy.
A Blade PC installed into a powered enclosure will immediately
power up.
Powering Down the HP CCI Solution
You can power down one or more Blade PCs or the entire enclosure.
Powering Down a Blade PC
To power down a Blade PC:
1. Be sure that the Blade PC is not active.
For specific information about Blade PC LEDs, see
Appendix E,
“LEDs and Switches.”
2. If the Blade PC is active, notify users and stop applications as
necessary.
3. Shut down the operating system. This may shut off the Blade PC
power.
