HP Apollo 2000 System, Maintenance And Service Manual

Page: 83 / 178

A message prompt to confirm the iLO settings reset appears.
6. Press Enter to reboot the iLO settings.
7. Press Esc until the main menu is displayed.
8. Select Reboot the System to exit the utility and resume the boot process.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent
boot-up. Access the Network Options screen again to view this IP address for later reference.
Riser boards
About this task
To remove the component:
CAUTION:
To prevent damage to the server or expansion boards, power down the server and remove all AC power
cords before removing or installing the PCI riser board assembly.
1. Power down the node .
2. Disconnect all peripheral cables from the node .
3. Remove the node from the chassis .
4. Remove the PCI riser cage assembly .
5. In a three-slot riser cage assembly, remove the riser cage bracket from the three-slot riser cage
assembly .
6. Remove all expansion boards from the riser cage assembly.
• Remove Accelerator 1 from the FlexibleLOM 2U node riser cage assembly
• Remove Accelerator 2 from the three-slot riser cage assembly
• Remove Accelerator 1 from the three-slot riser cage assembly
7. Disconnect all cables from the riser board.
8. If replacing a riser board in a three-slot riser cage assembly, remove the PCIe transfer board .
9. Remove the failed riser board.
• PCIe x16 left riser board (Single-slot left PCI riser cage assembly)
• PCIe x16 left riser board (Single-slot 2U node PCI riser cage assembly)
Riser boards 83