HP Apollo 2000 System, Maintenance And Service Manual

Page: 82 / 178

Dedicated iLO management port module
Observe the following rules and limitations when installing an dedicated iLO management port module:
• If a dedicated iLO management port module is installed in a node, the node can only connect to a network
through the dedicated iLO management port module.
• If a dedicated iLO management port module is installed in a node, the node cannot be accessed through
the RCM module .
• If using the RCM module iLO ports or the dedicated iLO management port module to connect to a
network, the network must operate at a speed of 1 Gb/s. The server cannot connect to the network if the
network is operating at a speed of 10/100 Mb/s or 10 Gb/s.
To remove the component:
1. Power down the node .
2. Disconnect all peripheral cables from the node .
3. Remove the server node from the chassis .
4. Place the node on a flat, level surface.
5. Remove any installed PCI riser cage assemblies .
6. Remove all rear I/O blanks .
7. Remove the failed dedicated iLO management port card.
To replace the component, reverse the removal procedure.
Enabling the dedicated iLO management module
To enable the dedicated iLO management module:
1. During the server startup sequence after installing the module, press F9 in the POST screen.
The System Utilities screen appears.
2. Select System Configuration | iLO 4 Configuration Utility .
The iLO 4 Configuration Utility screen appears.
3. Select Network Options , and then press Enter .
The Network Options screen appears.
4. Set the Network Interface Adapter field to ON , and then press Enter .
5. Press F10 to save your changes.
82 Dedicated iLO management port module