HP 8167A, User Manual, Page: 109 / 262

5
Set <value> to the actual wavelength measured with a
wavelength meter . Repeat the call to WAVEACT until the new
wavelength is accurate enough, or will not get any better .
When WAVEACT is active , you see the message EXT. REF. at
the bottom left of the Tunable Laser Source Screen.
Y ou cannot call WAVEACT with a value that would set the
Tunable Laser Source to a wavelength that is not in its
wavelength range .
F or example , suppose the current wavelength is at the lower
wavelength limit of, say , 1480.000 nm. Calling WAVEACT with a
dierent value would cause the wavelength to be corrected to
be outside the valid range .
So , after WAVEACT 1480.009 , the Tunable Laser Source will
attempt to set a new wavelength of 1479.991 nm, which is
outside the wavelength limits .
Note
It is advisable not to call WAVEACT with modulation or coherence
control on.
WAVEACT is not available on HP 8167A models with serial
numbers lower than 3424Gxxxxx, or on any HP 8168A models .
F or an example of the use of WAVEACT , see \Example 5 -
Increased Tuning Linearity" in Chapter 6.
Example WAVEACT 1541nm
Remote Commands 5-39