6.
Remove the two Phillips PM2.0×3.0 screws
(1)
that secure the optical drive bracket to the optical
drive.
7.
Remove the optical drive bracket
(2)
.
Reverse this procedure to reassemble and install an optical drive.
Upgrade bay device
Description
Spare part number
Upgrade bay device cradle
502322-001
Before removing the upgrade bay device, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC Adapter from the computer.
4.
Remove the battery (see
Battery on page 50
).
Remove the upgrade bay device:
1.
Position the computer with the front toward you.
2.
Loosen the Phillips PM2.5×9.0 captive screw
(1)
that secures the upgrade bay device to the
computer.
3.
Remove the four Phillips PM2.5×4.0 screws
(2)
that secure the upgrade bay device to the
computer.
4.
Insert a flat-bladed screwdriver or similar tool into the upgrade bay device tab access
(3)
and
press the tab to the left to release the upgrade bay device from the computer.
60
Chapter 4 Removal and replacement procedures