Emulator Reconfiguration:
– Selecting microprocessor to be emulated.
– Selecting CPU operation mode.
– Defining the reset value of the stack pointer.
Memory Configuration:
– Enabling the high speed access mode
– Selecting the background or foreground emulation
monitor.
– Mapping memory.
Emulator Pod Configuration:
– Selecting target memory access data size.
– Enabling interrupts from the target system.
– Enabling watch dog timer.
Debug/Trace Configuration:
– Enabling breaks on writes to ROM.
– Enabling tracing refresh cycles.
– Enabling tracing DMA cycles.
– Enabling tracing HOLD/HLDA cycles.
– Enabling 16bit symbol display.
– Defining the DT register value for symbol display.
Simulated I/O Configuration:
Simulated I/O is described in the
Simulated I/O reference manual.
Interactive Measurement Configuration:
See the chapter on
coordinated measurements in the Softkey Interface Reference manual.
4-2 Configuring the Emulator
Summary of Contents for 64146A
