![HP 64146A User Manual Download Page 76](http://html.mh-extra.com/html/hp/64146a/64146a_user-manual_164062076.webp)
Note
When you specify "fcode", the "fcode" becomes the new default to
display memory. That is, once you specify "fcode i", you need to
specify "fcode none" to display emulation memory.
When you don’t map the internal RAM and SFR area to emulation
RAM (when you don’t copy the contents to emulation memory), you
can access the internal RAM and SFR without specifying "fcode"
syntax.
Note
The contents of emulation memory is updated only when user program
writes data to internal RAM (or SFR). Therefore, the contents of
emulation memory may be different from the actual value of internal
RAM. Especially, you should pay a close attention when seeing flags
of SFR.
Note
When you modify memory, the emulator breaks to the monitor, and
writes data to internal RAM or SFR. Therefore, user program is
suspended when modifying internal RAM or SFR.
Emulator Pod
Configuration
To access the emulator pod configuration questions, you must answer
"yes" to the following question.
Modify emulator pod configuration?
Target memory
access size?
This question allows you to specify the types of cycles that the
emulation monitor use when accessing target system memory. When
an emulation command requests the monitor to read or write target
4-16 Configuring the Emulator
Summary of Contents for 64146A
