HP 5400R zl2 Series, Nstallation And Getting Started Manual

Page: 27 / 140

1-17
Introducing the HP 5400R zl2 Switches
Front of the Switch
Introducing the HP 5400R zl2
Sw
itc
hes
This button is provided for your convenience, but its presence means that
if you are concerned with the security of the switch configuration and
operation, you should make sure the switch is installed in a secure
location, such as a locked wiring closet.
■ Restoring Factory Default Configuration - When pressed with the
Reset button in a specific pattern, the Clear button clears any configura-
tion changes you may have made through the switch console, the web
browser interface, or SNMP management, and restores the factory default
configuration to the switch. The specific patterns to accomplish the
Restore Factory Default Configuration are:
i. Press both the System Reset and Clear buttons simultaneously.
ii. Release the System Reset button, but continue to hold the Clear
button.
iii. Release the Clear button immediately when you see the Test LED
begins to flash on both the Management Modules.
For the specific method to restore the factory default configuration, see
“Restoring the Factory Default Configuration” in chapter 4, “Troubleshooting”
of this manual.
MM Shutdown Button
When you want to remove a module, the MM shutdown button halts all the
management functions. It will not reboot when this button is pressed.
If the system is running with two management modules and the MM shutdown
button is pressed on the active module, this causes a failover to the standby
module.
If the system is running with two management modules and the MM shutdown
button is pressed on the standby module, no failover occurs.
MM Reset Button
The MM reset button resets the Management Module to which it is attached.
If the system is running with two management modules, and if the active
module is reset, this causes a failover to the standby module.
If the system is running with two management modules and the on reset is the
active, no failover occurs.
When a user presses the reset button, the module will be reset and will reboot.