30. Monitor the system while the SP uses the site key. When the system communications
configuration is complete, the following message appears:
*** starting final MOB phase
Fix passwords
Enabling key change on reboot ...
Disabling sendmail...
verifying postfix status...
Setup to run all ST/SP tasks at boot time
Add SPID to ppp id
Cleanup MOB
Updating PAM settings
Rebooting....
The SP automatically restarts.
Welcome to the 3PAR Service Processor Moment of Birth
Rebooting....
Continue to
“Installing HP 3PAR OS Files ” (page 61)
.
Configuring the SP With Secure Network Mode
1.
Connect the maintenance PC to the SP through serial connection, then power on the SP and
log in as the
root
user.
2.
Press
ENTER
or type
yes
and press
ENTER
to begin the Service Processor Setup Wizard.
Welcome to the 3PAR Service Processor Moment of Birth
Enter Control-C at any time to abort this process
Are you ready to configure the SP at this time? (yes or no) [yes]:
[enter]
3.
Press
ENTER
or type
no
and press
ENTER
.
Site Security Level
Enter Control-C at any time to abort this process
A Secure Site is a site where the customer will NEVER allow a 3PAR SP
to access the public internet. Thus the SP public interface will be used only to
access and monitor the 3PAR InServ attached to this SP.
Is this a Secure Site? ( yes or no ) [no]
[enter]
CAUTION:
If you answer
yes
, the SP is not able to communicate with HP Central. A complete
rebuild of the SP is required if the SP needs to establish communication link with HP Central.
4.
Type
2
to assign Secure Network Mode for file transfer/remote operations.
Type of transport control
Enter Control-C at any time to abort this process
42
Installing Storage Software Manually
