Using the Auto-Adjustment Function
You can optimize the screen performance for the VGA (analog) input by using the
Auto/OK
button on
the monitor and the auto-adjustment pattern software utility on the CD provided.
Do not use this procedure if the monitor is using a DVI or HDMI input. If the monitor is using a VGA
(analog) input, this procedure can correct the following image quality conditions:
●
Fuzzy or unclear focus
●
Ghosting, streaking or shadowing effects
●
Faint vertical bars
●
Thin, horizontal scrolling lines
●
An off-center picture
To use the auto-adjustment feature:
1.
Allow the monitor to warm up for 20 minutes before adjusting.
2.
Press the
Auto/OK
button on the monitor front panel.
●
You can also press the
Menu
button, then select
Image Control > Auto-Adjustment
from
the OSD Main Menu. Refer to
Adjusting the Monitor Settings on page 21
in this chapter.
●
If the result is not satisfactory, continue with the procedure.
3.
Insert the CD in the disc drive. The CD menu is displayed.
4.
Select
Open Auto-Adjustment Software
. The setup test pattern is displayed.
5.
Press the
Auto/OK
button on the monitor front panel to produce a stable, centered image.
6.
Press the
ESC
key or any other key on the keyboard to exit the test pattern.
ENWW
Using the Auto-Adjustment Function
19
Summary of Contents for 2310t
Page 1: ...HP 2310t and 2310ti LCD Touch Monitors User Guide ...
Page 4: ...iv About This Guide ENWW ...
Page 8: ...viii ENWW ...
