Hotpoint WMXTF922GUK, Service Information

Page: 26 / 27

26 of 27
Service Manual UK
Indesit Company
English
E Top Concrete Weight
1. Remove the top cover (A).
2. Remove the 3 fixing bolts and lift clear.
F Dispenser/Valve Assembly
1. Remove the top cover (A).
2. Remove the drawer.
3. Remove the screws securing the dispenser to the control panel.
4. Remove the inlet valve fixing screws to the rear of the cabinet.
5. Remove the control panel (C).
6. Unhook the dispenser outlet hose from the dispenser.
7. Remove the wires, lift clear and remove the dispenser valve assembly.
G Fill Valves
1. Remove the top cover (A).
2. Remove the inlet valve fixing screws to the rear of the cabinet.
3. Remove the control panel (C) and ease the dispenser assembly forward.
4. Remove the screws securing the valve to the dispenser.
5. Disconnect the wiring.
H Door Seal
1. Remove the top cover (A).
2. Remove the outer wire clamp, attaching the door seal to the cabinet (R).
3. Release the door seal from the cabinet front.
4. Remove the door seal from the tank front. The seal is fixed to the tank front by a sprung band.
I Door Interlock
1. Remove the restrainer securing the door seal to the front panel (R).
2. Remove the two securing screws and working from the drum aperture behind the door seal
disconnect the wiring.
J Belt and Pulley Removal
1. Remove the back panel (B) to gain access to the belt.
2. Using pulley locking tool, Part No. C00560114 (560114), remove the pulley fixing screw and ease
pulley away from the shaft.
K Mains Suppressor
1. Remove the top cover (A).
2. Remove the screw securing the suppressor and mains cable unit to the cabinet.
3. Lift unit upwards and withdraw from cabinet.
Note: This unit is not a customer fit part.
L Drum Assembly
1. Remove the top cover (A), back panel (B), control panel (C), dispenser (F) and motor (N).
2. Remove the screws securing pump to front panel.
3. Disconnect the wiring attached to the outer drum via cable clips and any earth wires.
4. Disconnect the tube from the pressure switch.
5. Unclip the dispenser outlet hose from the dispenser and remove door seal from front panel.