Adjusting the support wheels
The support wheels stabilise the seed bar and
ensure uniform working depth over the entire
working width.
Adapter plates may be mounted to the flanges
of the support wheel booms:
¾
Support the machine with appropriate means.
¾
Loosen the screw connection, insert additional
adapter plates and tighten the screws again.
The illustration shows the left side of the
machine. Insert the same number of adapter
plates at all four points on the machine.
NOTE
¾
Adapt the height of the support wheels to the
respective ground conditions.
Adjusting the axle
The axle of the machine can be adjusted.
¾
Support the machine with appropriate means.
¾
Loosen the screw joints and insert the screws
again at a different position.
The following illustration shows the basic set-
ting. Make the same adjustments on both sides.
+
-
50
51
Summary of Contents for Pronto 6 NT
