Retrofits
Structural changes and extensions can adverse-
ly affect the functionality and the operational
safety of the machine. This can lead to severe
or even fatal physical injuries.
¾
Do not make any structural changes or ex-
tensions to the machine that have not been
approved by HORSCH.
¾
Structural changes and extensions must only
be made in an authorized workshop or by an
operator who has been trained by HORSCH.
¾
Comply with country-specific instructions for
weights, weight distribution and dimensions.
For equipment influencing the weight or weight
distribution the regulations concerning towing
facility, support and axle load must be checked
and complied with.
For machines without brakes a brake system
may need to be retrofitted if the permissible
weight limits are exceeded.
In case of changes concerning data mentioned
on the type plate, a new type plate with updated
data must be attached.
In case of changes which concern the data in
the type approval, this type approval needs to
be renewed.
Care and maintenance
Inappropriate care and maintenance puts the
operational safety of the machine at risk. This
can lead to accidents with severe or even fatal
physical injuries.
¾
Conform to prescribed schedules for repetitive
tests or inspections.
¾
Service the machine according to the
maintenance plan, see chapter “Care and
maintenance”.
¾
Only perform the work described in these
operating instructions.
¾
Before starting maintenance and service work
park the machine on level and firm ground and
secure it against rolling away.
¾
Depressurise the hydraulic system and lower
or support the implement.
¾
Prior to working on the electrical system,
disconnect it from the electric current supply.
¾
When performing welding work on the ma-
chine, disconnect the cables from computers
and other electronic components. The ground
connection must be as close as possible to
the welding point.
¾
Before cleaning the machine with high pres-
sure cleaner cover all openings, which should
stay clear of water, steam or cleaning agents
for reasons of safety or operation. Do not aim
the water jet directly on electric or electronic
parts, on bearings or the fan.When using high
pressure cleaning equipment or steam jet, you
should always keep at least 50 cm distance
from the machine parts.
¾
Hopper, metering units, hoses and coulters
are contaminated with fertilisers and dressed
seed. Wear suitable protective outfit when
cleaning. Avoid contact and do not breath
the exhaust air.
¾
After cleaning, check all hydraulic lines for
leaks and loose connections.
¾
Check for chafing and signs of damage. Rem
-
edy any faults immediately!
¾
Screw connections loosened for the purpose
of care and maintenance work must be
retighten after work is completed.
¾
All other maintenance and repair tasks,
which are not described in the operating
instructions, must only be carried out by
an authorized professional workshop or
by an operator who has been trained by
HORSCH for this purpose.
Do not clean new machines with a steam
jet of a high pressure cleaner. The paint
takes approx. 3 months to cure and could
thus be damaged if this time has not yet
expired.
13
Summary of Contents for Pronto 6 NT
