Horizon Fitness Bookletmaker FC-200A, Manual

Page: 66 / 218

58
3-4 Doing a Test Binding
Adjusting the fore-edge trim section
The booklet which has been transported to the
fore-edge trim section stops. It is held by the
transport belt.
6
7
Confirm that the booklet is held
correctly by the transport belts and
there are no gap between the book-
let and the stopper.
- If the booklet is held diagonally,
E: Adjust the gap between the booklet
and the transport belt.
- To do fore-edge trimming, close the cover
and press .
Press .
The booklet is delivered.
If there is a problem with the binding quality
- To change the stitch distance,
adjust the value of setting F.
- If the fold line is shifted parallel,
adjust position H.
- If the stitches are shifted parallel to the fold line,
adjust the value of setting G.
- To change the corner stitch position,
adjust the value of setting J.
- Adjust the value of setting I to change the fin-
ishing size.
E I E I
21102
30403E1
6 6 6 7
Binding-Fine Adjust-Fore-edge Trim Section Screen
If the gap between the booklet and the transport
belt is too wide, the booklet is bound and skewed
when the booklet hits the stopper.
If the gap is too narrow, the booklet may be
pressed against the stopper and skewed.
A A
B B
G G F F
21102
30403F1
H
C
D
H
C
D
21102
30403G1 4 5
Binding-Fine Adjust-Stitch Section Screen
Binding-Fine Adjust-Fold Section Screen
If the fold line and the stitch line are not aligned
when doing saddle stitching, first check if the
booklet is being folded in the proper position, then
match the stitch position to the fold line.
- Position H can be adjusted only when the sheets
are being jogged.
- If you notice skewed folding, go to Chapter 5,
Troubleshooting.
- Position G can be adjusted only when the
sheets are being jogged.
- If you notice skewed folding, go to Chapter 5,
Troubleshooting.
11119
30403F1
The stitch position for corner stitching and side
stitching is set at 6 mm (0.24") from the sheet
edge.
3-4-3 Do a Test Binding and Check
the Settings