Honeywell UltraKey Touch HJC4000, Installation And User Manual

Page: 54 / 78

54
Installing UltraKey Touch with PTZ
Step 2: Configure the Controller for PTZ
Note In the Standalone main menu, press Ent , and rotate the slider to enter PTZ
settings or press PTZ . You can set the PTZ Name, Address, and Protocol.
1. Install and connect the controller to a power source, if it is not already connected.
The UltraKey Touch LCD displays.
2. Press the Login key and enter the password: 1234 . Press Ent to confirm.
3. From the home screen, press Alt > Clr to enter the
System Configuration menu.
4. Scroll to and select Standalone Settings . Press
Slider_Right or Ent to enter the Standalone Set menu.
5. Rotate the slider to select the PTZ, press Slider_Right
to enter PTZ settings.
6. Press Slider_Down or LCD arrow key up/down, and
the following figure is displayed on LCD screen:
a. Use the
Slider_Up/Down keys to scroll to different
controller protocols. Press Ent to save.
b. Use the Slider_Up/Down keys to scroll to change
the name of the controller. Press Ent to save.
c. Use the Slider_Up/Down keys to scroll to an
address between 1 and 128 to assign to the
controller. Press
Ent to save.
Return to the home screen.
If the keyboard is in DVR mode after changing to PTZ
settings, then the home screen displays this message:
Select
Yes or No to change the work mode of the keyboard.
If the keyboard is in PTZ mode after changing to PTZ settings, then the home screen does
not display that message.
Step 3: Configure Serial Port of the Controller
1. Press Alt > Clr to enter the System Configuration top menu.
This indicates that the
keyboard is in PTZ mode.
CAM 001
ST User2
This indicates that the
keyboard is in DVR mode.
CAM 001 DVR 1
ST User2
System Configuration
Standalone Setting
Standalone Set:
PTZ
PTZ Setting:
Protocol
PTZ Setting:
Name
PTZ Setting:
Address
Change to PTZ mode?
Yes