62
Installing UltraKey Lite with MAXPRO-Net
3.
Enter the
IP address
and
Port Number
of the MAXPRO-Net server under
MAXPRO
Device Network Setting
.
4.
Under
Serial Port Setting
, select a
Baud Rate
from the drop-down list. Options are
9600
or
19200
bps.
5.
Select a
Connect Mode
from the drop-down list. Options are
232
or
422
.
6.
From the
Joystick speed
drop-down list, select
Normal
or
High
.
7.
Click
Apply
to save the configuration,
Cancel
to exit without saving or
Default
to
restore all factory default values.
Figure 4-14
MAXPRO Configuration Tab
Checking the Network Connection Using the Ping Function
After the IP address is entered and applied, press the
Ping
button.
•
A green Ping button indicates the device at this IP address has replied to the ping.
•
A red Ping button indicates the device at the IP address did not reply. Please check
that the IP address is correct and that there is a valid network path between the two IP
addresses.
Step 3A: Configure the Controller for a Serial Port Connection
1.
From the side menu, click
Serial Port Configuration
.
2.
Under
Serial Port1 Settings
, select the following from each drop-down list as
required:
•
Baud Rate
: 9600 or 19200 bps
•
Parity
: none, even or odd
•
Stop Bits
: 1 or 2 bits
•
Data Bits
: 7 or 8 bits
•
Serial Mode
: RS232, RS422 or RS485
3.
If required, repeat
for
Serial Port2 Settings
.
Summary of Contents for UltraKey Lite HJC5000
