Commissioning
MAN0984_Iss 4_01/19
Touchpoint Plus
Pt. No. 3011M5001
55
Technical Handbook
6.3.4
How To Change a Password
You can only change your own or lower level passwords. The initial default password for all levels is TPPL but it
should always be changed during or immediately after Commissioning.
1)
Login as Service or Administrator.
2)
Touch
Menu icon>Configuration>Security>Password
.
3)
Touch an access level icon and touch each box to open a keyboard.
4)
Input the currently logged in password, the new password, and confirm the new password. (Toggle the [
↓↑
] key
for upper / lower case letters, and the [?123] key for symbols.
5)
Touch [Finish] to close the keyboard before touching the next box.
6)
Touch [Change] when finished.
Note:
The stored passwords will be replaced with the new passwords so you must also update any written copies.
6.3.5
Forgotten Passwords
The Administrator or Service Engineer can reset lower level passwords but the Administrator password cannot be
changed or reset without entering the current Administrator password.
To reset a lower level password:
1)
Log in as Administrator* or Service.
2)
Go to
Menu>Configuration>Security>Password
.
3)
Touch the user to change, then enter your own password, and then enter and confirm the new password.
4)
Alternatively you can use the [Reset] button to reset to the default password TPPL , and then allow the user to
set their password as shown above.
* Lost Admin passwords can only be reset by authorised Honeywell Field Service Technicians. See the back page or
select
TPPL Menu>Information>Service Contact
for details.
CAUTION
For security reasons you should change the default Administrator, Service and Operator passwords at the
earliest opportunity and periodically thereafter.
At the very least you should keep a copy of the Administrator password in a safe place as it cannot be
recovered if lost or forgotten.
Careless password management can allow unauthorized access to the system, which may cause safety
issues that are the user's sole responsibility. Honeywell will not be liable if any end-user fails to follow
established security protocols or the guidelines in this manual.
