ID2000 Series Operating Manual
Appendix 1
A1 - 9
997-434-000-4, Issue 4
May 2010
PANEL STATUS:
EVACUATE
This is the condition when the EVACUATE pushbutton
has been pressed.
The condition continues to be shown until superseded
by a higher-priority condition or until cleared by pressing
the SILENCE SOUNDERS pushbutton).
The LCD displays the message shown below:
The indications of the panel and external equipment are
as follows:
LAMP indications:
POWER (green):
O N
All others
OFF
Internal sounders:
OFF
Circuits Controlled Internally:
Sounder Circuits: if not substituted
by alternative devices in matrix
program, both circuits on
STEADY
FIRE, FAULT relays:
OFF
External Devices:
depending on programmed
EVACUATE schedule some
or all Control modules may
be ON, either steady or pulsing.
The LEDs of active Control Modules (those for which the
control output is ON) will be OFF.
The LEDs of all other sensors and modules should either
give short pulses or be OFF altogether, as configured.
The LED above the EVACUATE pushbutton is ON.
EVACUATE
(date)
(time)
(blank) or (System Normal message)