ID2000 Series Operating Manual
Operator
Actions at Panel
37
997-434-000-4, Issue 4
May 2010
If a printer is installed, all events are printed out at time
of occurrence unless the printer is disabled. However, it
is possible to obtain a repeat printout of a selection of all
recorded events (up to the maximum of 600) spanning
any time period.
To re-print the event log:
1
Follow the display procedure until you have located
the
first
event that you want to re-print, and it is on
display in scrollable (use
and
to scroll through
the events) format. Now press
and you will get the
question shown below and described above:
2
Press
twice
without changing the date or time
, then
the scrollable display of the event you had selected
will re-appear along with the prompt shown below:
3
If you answer
, the question shown below is
displayed:
You should select a date and time
after
the
last
event
you want re-printed, using the same method as
described above. If you press
twice without
changing anything, re-printing is carried out all the
way up to the present time.
Note:
When any portion of the event history is re-printed,
the original sequence numbers of the re-printed
events are also reproduced. This enables you to
determine, on inspecting the printout, where the
re-printed data ends and ‘live’ event logging re-
commences.
4.10.4 Printer Control Modes
Selection of option ‘2’ offers a choice of three printer
control modes:
The panel always powers on with the printer in ‘Normal’
mode. Select option ‘1’ to hold the printout data in memory
but not print it. Select option ‘2’ to discard the printout
data altogether.
During panel mains failures, the printer status is
equivalent to being in ‘Hold’ mode. However, if the printer
is manually set to ‘Hold’, it does not revert to ‘Normal’
when the mains is restored.
DATE & TIME from which to review?
Wed 16-Aug-00 12:30:00 (use
↑↓
↑↓
↑↓
↑↓
↑↓
)
RE-PRINT Log from this point (
!
!
!
!
!
/X)?
RE-PRINT Log up to when?
Wed 16-Aug-00 12:30:00 (use
↑↓
↑↓
↑↓
↑↓
↑↓
)
0=Normal/1=Hold/2=Disable:
0