Honeywell Marathon, User Manual

Page: 240 / 286

13 - 48
Convert Code 39 to Code 32
Note: Code 39 (page 13-47) must be enabled in order for this parameter to function.
Set this parameter by scanning either of the bar codes shown below.
Set Length(s) for Code 39
Lengths for Code 39 may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains. If Code 39 Full ASCII is
enabled, Length Within a Range or Any Length are the preferred options.
See ASCII Character Equivalents (page 13-86).
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only Code 39
symbols containing 14 characters, scan the following bar code and then “1” and “4” bar codes using
Imager Keypad
Number Symbols (page 13-84). Single digits must be preceded by a zero. Default = 2.
To begin setting one discrete length, scan this One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Default = 55.
Two Discrete Lengths (Parameter L2)
This option decodes only those codes containing two selected lengths. For example, when you want to scan only Code
39 symbols containing 2 or 14 characters, scan the following bar code and then “0”, “2”, “1” and “4” bar codes using
Imager Keypad Number Symbols (page 13-84)
To begin setting two discrete lengths, scan this Two Discrete Lengths bar code:
Enable Convert Code 39 to Code 32
* Disable Convert Code 39 to Code 32