36
Installing UltraKey Plus with VideoBloX
Figure 2-6
Ethernet Port Connections to VideoBloX
Step 2: Set and Configure for an Ethernet Connection
To set and configure for an Ethernet connection:
Note
No entry is required in the baud rate field for Ethernet connections.
1.
Apply AC power to the controller after all the devices have been connected
correctly.
2.
Press Alt + Clr + Home keys on the controller to
display Login page
.
3.
Enter the PIN password 3434.
The Settings screen displays.
4.
If current mode is MAXPRO mode, change it to VB mode by pressing the Mode
Maxpro button
and
logging into Setting menu again.
5.
Press Hardware Config.
The current controller setting is displayed.
6.
Press Port Settings and then Ethernet.
The Ethernet
Setting
s
are
display
ed
.
7.
Press IP Address and use the numeric keypad or LCD Touch Panel to enter an IP
address as required.
8.
Press the Subnet Mask, using the LCD Touch panel to enter a NetMask as required,
you can use Touch Panel as well.Press Enter.
9.
Press Default Gateway. Using the number key or LCD Touch Panel to enter a
Gateway as required. Press Enter.
10. Press Sys.Cntl.IP Address, using the number key or LCD Touch Panel to enter the
address of device as required. Press Enter.
11. Press Save to exit from the Ethernet Settings menu.
VideoBloX
Ethernet Port
RJ45 network cables
Ethernet
Controller 1
Controller 32
TCP/IP
TCP/IP
Network
Summary of Contents for #HZ-7000 - Sure-set Digital Heater Fan
