Honeywell HCD5HIH, Reference Manual

Page: 22 / 104

22
Installation and Setup
Note If you are using PoE (802.3 af), power will automatically be supplied to the
camera through the network cable.
2. Plug in the power supply. Use a screwdriver to first loosen the ~AC 24 V terminal
screws on the terminal block.
Note To ease installation, the terminal block can be removed. The power
connections of the removable terminal block are not polarity-sensitive.
Connect either power lead to either connector terminal.
3. Secure the power leads by tightening the terminal screws until snug.
4. Plug the power supply into an appropriate power source.
Note For secure installations, surface-mounted cables should be protected by
plastic or metal cable covers.
Note If your installation involves a 24 V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
Caution Installation must be performed by a qualified service technician. The
proper wire gauge for the distance and number of cameras must be
determined to maintain 24 V AC at each camera.
Caution When powering the camera from 24 V AC, a UPS source should be
considered to ensure satisfactory performance.
Note Connect power either from a 24 V AC source or CAT5 Ethernet connector
(PoE). It is not recommended to connect both power sources at the same
time.