fiGuRE 6. wiRinG connEcTionS AT DETEcToR
SLC (–
)
SLC (+)
SLC (–
)
SLC (+)
RESET
I NPUT
TEST
INPU
T
AUX (–)
REMOTE
ALARM OUT
NOT
USED
REMOTE
TROUBLE OUT
TEST
OPTION (–)
TEST
OPTION (+)
T3
T2
T1
C0260-01
fiGuRE 7. wiRinG DiAGRAM
+ –
+
–
+
+
TO NEXT
DEVICE
FROM PANEL OR
PREVIOUS DEVICE
LISTED
REMOTE
POWER
SOURCE
* Only used for
BEAM355S. See
electrical ratings.
COMMUNICATION LINE
32 VDC MAX.
TWISTED PAIR IS
RECOMMENDED.
–
–
–
+
T3
T2
T1
C0337-01
fiGuRE 8. wiRinG DiAGRAM (RTS451)
RTS451/KEY
DETECTOR
PIN 1
REMOTE ALARM OUT
T2-1
T2-2
T2-4
T2-3
AUX (–)
POWER IN +
T1-1
T1-2
T1-3
T1-4
POWER IN –
POWER OUT +
POWER OUT –
RESET INPUT
TEST INPUT
T3-3 REMOTE TROUBLE OUTPUT
OPTIONAL YELLOW LED
PIN 2
PIN 4
PIN 3
PIN 5
C0328-01
fiGuRE 9. wiRinG DiAGRAM (RTS451)
BEAM355S
Alarm
Signal
Circuit
(Note 1)
T2-1
T2-2
Note 1: See electrical ratings section of this
manual for circuit output ratings.
SLC (+)
SLC (–)
Red
C0329-00
inSTAllATion / AliGnMEnT
Reference Figures 10 through 14 for installation, alignment, and maintenance.
The alignment of the BEAM355/BEAM355S is divided into four steps: coarse
alignment, fine adjustment, final gain adjustment, and final verification. It is
necessary for all four steps to be executed properly to ensure proper alignment
of the product. If the detector and reflector are mounted per Mounting Loca-
tions and Mounting Instructions sections of this manual and the alignment
procedures are executed properly, false alarms and nuisance trouble signals
will be minimized.
PRE-AliGnMEnT chEckliST
Ensure that both the detector and reflector are mounted securely to
•
stable surfaces.
Ensure that all wiring is correct.
•
Ensure that terminal blocks are fully seated into their receptacles on
•
the detector.
Complete any wiring dressing to minimize movement to the detector
•
once the alignment procedure is completed.
Ensure that the appropriate number of reflectors are used for the in-
•
stalled distance. Distances between 230 and 328 Feet (70 – 100m) require
additional reflectors (4 total). The BEAMLRK accessory should be used
in these cases.
Ensure that the line of sight between the detector and reflector is clear
•
and that reflective objects are not too near. See Mounting Instructions
for more details.
Ensure that both the detector and reflector are mounted within their
•
operational parameters for off axis angles. See Mounting Instructions
for more details.
Disable the zone or system to prevent unwanted alarms before applying
•
power.
Ensure power to the detector is “ON”.
•
Ensure that the appropriate address is set on the code wheels.
•
You are now ready to begin the alignment procedure.
F300-29-00
5
I56-2425-007R
Summary of Contents for FireLite BEAM355
Page 11: ...F300 29 00 11 I56 2425 007R ...
