Honda WDP30X, Instructions Manual

Page: 10 / 75

Date of Issue: April 2008
2-1
WDP30X
2. SERVICE INFORMATION
1. SERVICE RULES
• Use Honda Genuine parts or their exact equivalent. Lower quality parts can damage the pump or reduce its
performance.
•
• Install new gaskets, O-rings, and seals during assembly.
• This pump uses metric fasteners and SAE (nonmetric) fasteners. Metric bolts, nuts, and screws are not
interchangeable with nonmetric fasteners. The use of incorrect tools and fasteners may damage the pump.
• When tightening nuts and bolts, begin with the larger-diameter or inner bolts, and tighten diagonally to the specified
torque values, unless a particular tightening sequence is specified.
• When tightening self-tapping screws, be especially careful to avoid cross-threading or overtightening.
• Clean parts in nonflammable solvent after disassembly.
• Lubricate sliding surfaces before assembly.
• After assembly, check parts installation and operation.
2. SYMBOLS USED IN THIS MANUAL
As you read this manual, you may find the following symbols with the instructions.
1. SERVICE RULES . . . . . . . . . . . . . . . . . . . . . . . . 2-1 5. TORQUE VALUES . . . . . . . . . . . . . . . . . . . . . . . 2-4
2. SYMBOLS USED IN THIS MANUAL. . . . . . . . . 2-1 6. TOOLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-5
3. SERIAL NUMBER LOCATIONS . . . . . . . . . . . . 2-2 7. TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . . 2-7
4. MAINTENANCE STANDARDS . . . . . . . . . . . . . 2-3

A special tool is required to perform the procedure.
(Commercially
available)
Commercially available tools are distinguished by the words (commercially available). They are
not available through the American Honda Parts Department. Most commercially available tools
shown in this shop manual can be ordered through the Honda Power Equipment (P/E) Tool and
Equipment program by calling (888) 424-6857. Refer to the Tool and Equipment program
catalog for a complete tool listing.

Apply grease

Apply oil
O x O (O) x () Indicates the diameter, length, and quantity of metric flange bolts used.
P. O-O P. - Indicates the reference page.