NSR150SP Maintenance
______________________________________________
3-18
Raise the rear wheel off the ground by
placing a support under the engine.
Turn the bearing holder with the pin
spanner provided in the tool kit until the
correct drive chain slack is obtained.
After adjustment, check the
chain
wear label on the rear caliper bracket.
If
the red zone on the label reaches the
outside index mark of the swingarm,
replace the drive chain with the new one.
Tighten the
bearing holder pinch bolt to
the specified torque.
TORQUE: 73 N.m (7.4 kgf.m, 54 lbf-ft)
Re-check chain slack and free wheel
rotation.
Lubricate the
drive chain with #80 - 90
gear oil.
Wipe off the excess chain oil.
CLEANING, INSPECTION AND
LUBRICATION DRIVE CHAIN
CAUTION
•
Chains with 0-rings should not be treated to
the following cleaning and oiling procedure.
This treatment will cause degradation of the
0-rings and loss of grease, thus shortening
chain life not use steam or high pressure
water washing. Use a chain spray
containing a cleaning agent or use gasoline
to clean the chain.
Clean the chain with suitable
detergent and wipe it dry.
Be sure the chain has dried
completely before lubricating.
http://mototh.com