NSR150SP RC Valve/Servo Motor
________________________________________________
9-10
Align the tab on the servo motor pulley with the 'Hi' mark
on the servo motor.
Connect the front RC valve control cable to the RC
valve timing pulley by compressing the control cable
spring.
Connect the rear RC valve control cable to the
RC valve timing pulley.
Align the notch on the RC valve timing pulley
and 'H' mark on the cylinder by turning the
adjuster holding the outer tube to prevent it
from being twisted.
Tighten the lock nut securely.
Recheck the tab on the servo motor pulley is
aligned with the mark on the servo motor.
Turn the RC valve timing pulley 5
O
to 10
O
in
several steps.
When the tab on the servo motor pulley aligns with the 'Hi' mark on the servo motor, the
notch on the RC valve timing pulley aligns with the 'H' mark on the cylinder.
If not so, reinstall again.
Check the RC valve control cable.
http://mototh.com