NSR150SP Cooling System
______________________________________________
6-7
Disconnect the reserve tank overflow tube.
Place a suitable container under the reserve
tank.
Remove the reserve tank cap from the
reserve tank and drain the reserve coolant.
Empty the coolant and rinse the inside of the
reserve tank with water.
Reconnect the reserve tank overflow tube.
Install the reserve tank.
Install and tighten the bolts securely.
Completely fill the system with the
recommended coolant through the filler
neck.
Remove the reserve tank cap and fill the
reserve tank to the upper level line.
Bleed air from the system as follows:
•
NOTE: Remove the filler cap before starting.
1. Shift the transmission into neutral.
Start the engine and let it idle for
2 - 3 minutes.
2. Snap the throttle 3 - 4 times to bleed air
from the system.
3. Stop the engine and add coolant up to
the filler neck. Reinstall the radiator
cap.
4. Check the level of coolant in the
reserve tank and fill to the upper level if
it is low.
RADIATOR
CAUTION
•
Be careful not to damage the radiator grills.
RADIATOR GRILL REMOVAL/INSTALLATION
Remove the side cowl and lower cowl.
(page 2-4).
Remove the screws.
Remove the tabs on the radiator grill from
the holes on the radiator.
Remove the radiator grill.
Installation is in the reverse order of
removal.
http://mototh.com