Honda HSM1336i, Owner'S Manual

Page: 56 / 144

54
OPERATION
Do not turn the mode selector switch to another position while the
snow blower is moving. The electronic control unit will interpret this
as a failure; the snow blower will stop moving and the auger will stop
turning.
When the snow blower and auger stop moving/turning, move the
main shift lever to the N (neutral) position, release the drive clutch
lever.
Check each part to verify it is in its proper position before resuming
operation.
3a. Clearing in AUTO mode
Setting the mode selector switch at the AUTO position can
simplify clearing the snow. AUTO mode keeps the auger from
rising, adjusts the engine speed automatically, etc.
1) Operate the chute control switch to
adjust the snow discharge direction
and angle (see page 27).
2) Operate the auger housing control
switch to adjust the auger to be
parallel to the road surface (see
pages 50 and 52).
USA model only:
• You can return the auger to the
initial position by pushing the
reset switch.
• If you return the auger to the initial
position by pushing the reset
switch, the auger can hit against the
road surface or can be raised from
the road, resulting in some snow
left on the ground, depending on
the road condition and the position
of the snow blower.
Adjust the auger height position
as needed.
CHUTE CONTROL SWITCH
RESET SWITCH
(USA model only)
AUGER HOUSING
CONTROL SWITCH
31V15621.book 54 ページ ２０１８年１０月１０日 水曜日 午前１１時４分