Honda HSM1336i, Owner'S Manual

Page: 125 / 144

123
TAKING CARE OF UNEXPECTED PROBLEMS
(2)Engine runs poorly.
SYMPTOM POSSIBLE CAUSE REMEDY
Hard to drive the
snow blower in forward
direction. Auger shear bolt is broken. Replace the auger shear bolt (see
page 91).
Auger height is not properly
adjusted. Auger height adjustment (see
page 50).
Snow is clogged in the
snow blowing mechanism. Use the snow clearing bar to
remove the snow (see page 71).
Snow blower does not
run. Drive motor overheated by
operation under excessive load,
which armed the protection
function. Release the drive clutch lever, stop
the work, keep the engine switch
in the ON position and wait until
the drive control warning indicator
(orange) does not blink (see
page 65).
Snow blower runs slowly. To prevent malfunction resulting
from drive motor overheating,
the drive power is reduced. Release the drive clutch lever, stop
the work, keep the engine switch
in the ON position and wait until
the drive control warning indicator
(orange) does not blink (see
page 65).
Hard to drive the
snow blower in reverse
direction. Auger height is not adjusted in
the HIGH position. Auger height adjustment (see
page 50).
Snow blower does not
move when squeezing the
drive clutch lever. Wheel pin in the track has
worked off. Consult an authorized Honda
dealer.
Warning indicator (orange) blinks
or comes on. Check the drive control warning
indicator (orange) for the
number of blinks (see pages 118
and 119). Consult with your
authorized Honda dealer.
*1
Steering lever does not
work at all (or it does not
work well). Snow blowing mechanism is
buried in deep snow. Lift up the snow blowing
mechanism.
Operate the main shift lever to
the slower position, squeeze the
steering lever and apply some
force on the handle to turn in the
direction you want.
Track does not stop or become
slower when squeezing the
steering lever. Steering lever sensor or drive
motor might be faulty. Consult
an authorized Honda dealer.
31V15621.book 123 ページ ２０１８年１０月１０日 水曜日 午前１１時４分