Honda GXE2.0H, Manual

Page: 55 / 71

6-7
dummyhead dummyhead
CONTROL UNIT
MOUNT STAY CLEARANCE CHECK
Remove the battery tray (page 5-4).
Measure the clearance between the PDU stay A [1] and C [2] at the points
“a” without force.
It should be within 4.6 – 8.0 mm (0.18 – 0.31 in).
The clearance cannot be adjusted.
If it is not within specification, check each installation part for deformation,
looseness, or damage.
Parts Remarks
[1] STOPPER PIN BOLT (2) INSPECTION: Check for wear or other damage.
[2] NUT (6 mm) (4)
[3] PDU STAY C REMOVAL/INSTALLATION: Release the lower side by sliding it and then the upper
side in sequence as shown to avoid damaging the mount rubbers (Installation is in the
reverse order).
[4] NUT (6 mm) (4)
[5] MOUNT RUBBER (4) INSPECTION: Check for cracks or other damage.
INSTALLATION: Align the two locating pins with the slot in the PDU stay C.
[6] BOLT (6 x 16 mm) (4)
[7] BRACKET STAY INSTALLATION: Face the weld nuts to the opposite side of the PDU.
[8] PDU STAY A
[9] PDU STAY B
[1]
[2]
a a