1-GB
Start by Reading These Important Safety Rules
WARNING: If your garage has no service entrance door, an outside quick release must be installed. This accessory allows manual operation of the garage door
from outside in case of power failure.
Keep garage door balanced.
Sticking or binding doors must be
repaired. Garage doors, door springs, cables, pulleys, brackets and
their hardware are under extreme tension and can cause serious
personal injury.
Do not attempt to loosen, move or adjust them.
Call
for garage door service.
Do not wear rings, watches or loose clothing
while installing or
servicing a garage door opener.
To avoid serious personal injury from entanglement,
remove all ropes
connected to the garage door
before installing the door opener.
Installation and wiring must be in compliance with your local building
and electrical codes.
This is a class 2 double insulated product,
connesction to earth is not required or provided
.
Lightweight doors of fiberglass, aluminum or steel must be
substantially reinforced to avoid door damage.
The best solution is
to check with your garage door manufacturer for an opener installation
reinforcement kit.
The safety reverse system test is very important.
Your garage door
MUST
reverse on contact with a 40mm obstacle placed on the floor.
Failure to properly adjust the opener may result in serious personal
injury from a closing garage door.
Repeat the test once a month and
make any needed adjustments.
This unit should not be installed in a damp or wet space.
Door must not extend over a public byway during
operation.
Fasten the
child warning label
adjacent to the lighted door control
button as a reminder of safe operating procedures.
Disengage all existing garage door locks
to avoid damage to
garage door.
Any door control buttons (if installed)
MUST be located where the
garage door is visible, but out of the reach of children. Do not
allow children to operate push button(s) or remote control(s).
Serious personal injury from a closing garage door may result
from misuse of the opener
.
Activate opener ONLY when the door is in full view, free of
obstructions and opener is properly adjusted. No one should
enter or leave the garage while the door is in motion. Do not allow
children to play near the door.
Use manual release only to disengage the trolley and, if possible,
ONLY
when the door is closed.
Do not use the red handle to pull the
door open or closed.
Disconnect electric power to the garage door opener before
making repairs or removing covers.
This product is provided with a transformer and power supply cord of
special design which,
if damaged, MUST be replaced by a
transformer from your local Chamberlain distributor and fitted by
a specialist
.
SAVE THESE INSTRUCTIONS
Table of Contents
Safety Rules
1
Before You Begin
1
Door Types
1
1
Tools Required
1
2
Hardware Provided
1
3
Completed Installation
1
4
Assembly
2
5 - 10
Installation
2
11 - 17
Adjustment
3
18 - 20
Test the Safety Reverse System
3
19
Install The Protector System™
(Optional)
3
Program Remote
3
20
Replace Light Bulb
3
21
Operation Of Your Opener
3
Care Of Your Opener
3
Maintenance Of Your Opener
3
Having a Problem?
3 - 4
Wiring the Multi-Function Door
Control Panel and the Lighted
Door Control Button (Optional)
4
22
Install Outside Quick Release
4
23
Replacement Parts/Accessories
4
24
Specifications
4
Page
Illustration(s)
Door Types
A
. One-Piece Door with Horizontal Track Only
B.
Sectional Door with Curved Track
NOTE:
Unit will not work with One-Piece Doors with Horizontal and Vertical Tracks,
Double-Wing Doors, or Canopy Doors.
1
ASSEMBLY HARDWARE
1. Square Head Screws
(2)
2. 8mm Carriage Bolt (1)
3. Cable Pulley
(1)
4. Pin
(1)
5. 8mm Lock Nut
(1)
6. Pulley Bracket
(1)
These safety alert symbols mean
WARNING
– a personal safety or property damage instruction.
Read these instructions carefully.
This garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with
the following safety rules.
Failure to comply with the following instructions may result in serious personal injury or property damage.
INSTALLATION HARDWARE
7. 6mm Nut
(6)
8. Concrete Anchor
(4)
9. 6mm Lag Bolt
(4)
10. 6mm Self-Threading Screw
(4)
11. 6mm Hex Bolt
(4)
12. Wire Clips
(3)
Before You Begin
1. Look at the wall or ceiling above the garage door. The header bracket
MUST
be
securely fastened to structural supports.
2. Do you have a finished ceiling in your garage? If so, a support bracket and
additional fastening hardware (not supplied) may be required.
3. Do you have an access door in addition to the garage door? If not, Model
1702EML Outside Quick Release Accessory is required.
Hardware Provided
3
Tools Required for Installation
2
C
Co
om
mp
plle
ette
ed
d IIn
ns
stta
alllla
attiio
on
n
As you proceed with the assembly, installation and adjustment procedures in
this manual, you may find it helpful to refer back to this illustration of a
completed installation.
4
(1)
Cable Pulley Bracket
(2)
Trolley
(3)
Chain/Cable Assembly
(4)
Rail
(5)
Hanging Bracket
(6)
Power Cord
(7)
Opener
(8)
Light Lens
(9)
Manual Release
Rope & Handle
(10)
Door Arm
(11)
Door Bracket
(12)
Header Bracket
Summary of Contents for HE60
