25
26
Send:
The “14” command enables the delay time to be set in seconds for
arming and disarming the alarm only on the detectors suitably
programmed in the Delay Mode Zone.
This enables the user to be able to enter and exit the protected rooms
with an adequate time delay before triggering the alarm.
SMS Command “14”: Single Zone Delay Time
The “21” command enables all the wireless accessories connected to
the control panel to be deleted.
No confirmation will be requested on sending the “21” command: all
the wireless accessories will no longer be recognised by the system.
It will be necessary to arrange for reprogramming.
Alternatively, to delete the sensors from the control panel, press the
Tamper key located on the back of the panel 3 times within 3 seconds.
SMS Command “21”: Delete Sensors
14
Forward>Edit
Single zone delay time
(0 - 300 sec.):
30
Single zone delay time
(0 - 300 sec.):
15
Set single zone delay time
successfully
N.B.:
This command sets a delay exclusively on the detectors
programmed in the Delay Mode Zone.
However the “11” command refers to all the detectors installed.
The “22” command enables all the RFID devices associated with the
control panel to be deleted.
No confirmation will be requested on sending the “22” command: all
the RFID devices will no longer be recognised by the system.
It will be necessary to arrange for reprogramming.
SMS Command “22”: Delete RFID Tags
The “0000” command enables the original factory settings to be
reinstated. It is equivalent to a total reset command. It should be used
with great care.
No confirmation will be requested on sending the “0000” command:
all the wireless accessories, the RFID devices, the telephone numbers,
the SMS numbers, the names of the RFID devices, the delay times, the
password, etc. are deleted.
It will be necessary to arrange for reprogramming.
Alternatively, to reinstate the factory settings, press the Tamper key
located on the back of the panel 5 times within the space of 3
seconds.
SMS Command “0000”: Total Reset
N.B.:
The commands “21”, “22”, “0000” will be carried out only if
received from previously stored numbers.
