Setting up the Cylinder Sanding Machine
ZSM 560 | Version 1.01
11
The machine must be fully assembled before it can be
put into operation. To ensure that the assembly process
runs smoothly, first clean any parts that are covered or
coated with a rust inhibitor (if applicable). Avoid chlorine-
based solvents, such as acetone or brake cleaner, which
can damage painted surfaces.
Proceed as follows to assemble the machine:
Step 1: Unpack the machine and check the carton con-
tents for the following.
Fig. 5: Mounting parts of the machine
Step 2: Insert the 4 rubber feet (Fig.6) into the holes un-
derneath the machine.
Fig. 6: Insert rubber feet
Step 3: Mount the table extension (Fig.7) to the feed
opening of the machine with screws and was-
hers. The height of the table extension can be
adjusted by turning the adjustment screws.
Fig. 7: Mount table extension
Step 4: Mount the handwheel for height adjustment on
the machine head using the screw, washer and
cap nut.
Fig. 8: Mount handwheel
Screw
Table extension
Table
connection
Table
extension
Summary of Contents for ZSM 560
Page 1: ...Instruction Manual Cylinder Sanding Machine ZSM 560 ZSM 560 Vario ZSM 560 ZSM 560 Vario ...
Page 27: ...Spare parts ZSM 560 Version 1 01 27 Spare parts drawing 2 Fig 35 Spare parts drawing 2 ...
Page 29: ...Spare parts ZSM 560 Version 1 01 29 Spare parts drawing 2 Fig 37 Spare parts drawing 2 ...
Page 32: ...www holzstar de ...
