Holzstar ZSM 560, Instruction Manual

Page: 6 / 32

6 ZSM 560 | Version 1.01
Safety
2.5 Safety labels at the Cylinder San-
ding Machine
The following safety markings are attached to the Cylin-
der Sanding Machine, which must be observed and follo-
wed.
Fig. 1: Safety labels
The safety markings attached to the machine must not
be removed. Damaged or missing safety markings can
lead to incorrect actions, personal injury and damage to
property. They must be replaced immediately.
If the safety markings are not recognizable and compre-
hensible at first glance, the machine must be taken out of
operation until new safety markings have been applied.
2.6 Safety devices
All necessary measures for connection are described in
this operating manual. The connection may only be
made after reading and understanding the instructions.
In case of any ambiguity, contact the dealer.
Installation errors, including electrical
connection errors, are not covered by the warranty.
Before connecting or disconnecting the machine, the po-
wer connection must be interrupted.
2.7 General safety instructions
- Read the operating instructions before operating
the machine.
- Keep the work area clean and well lit. Cluttered or
dark areas invite accidents. Keep the floor free of
tripping hazards and dirt.
- Do not operate power tools in potentially explosive
atmospheres, e.g. in the presence of flammable li-
quids, gases or dust. Power tools produce sparks
that can ignite dust or the fumes.
- Do not expose the machine to rain or wet conditi-
ons.
- Check power supply at regular intervals. Do not
use defective cables.
- Never use the cord to carry, pull or unplug the ma-
chine.
- Keep the cable away from heat, oil, sharp edges or
moving parts.
- Never touch rotating or moving parts.
- Never work with the machine when you are not
concentrated.
- Keep children and untrained personnel away from
the machine.
- As soon as a safety device has been triggered or
has failed, the machine may only be started up if
you have eliminated the cause of the fault and
have made sure that there is no danger to persons
or objects.
- Always report electrical faults to an electrician.
- Switch off the machine when work is interrupted.
- Wear appropriate safety clothing (safety shoes,
safety goggles, respiratory protection, etc.).
- Check safety devices for correct function before
starting work. If safety devices are damaged, the
machine must not be put into operation.
- Read and understand the safety instructions atta-
ched to the machine.
- Carry out regular maintenance work.
- Do not overload the machine.
- If the machine does not operate normally, inform
the supervisor immediately.
- Use caution when people are in the work area.
- Never modify electrical or safety devices.
- Never remove mechanical or electrical safety de-
vices.
- Always keep hands away from the working area of
the grinding drum.
- Check feed belt from time to time to make sure
there is no dirt or sawdust between components.
- Pay special attention when transporting or reas-
sembling; follow transport instructions.
- If possible, secure the machine at the workplace.
- Never carry out a grinding operation if the cover of
the grinding drum has been removed.
- Before starting work, check all screws and safety
devices for tightness.
- Never force the workpiece into the feed opening of
the machine.
- Allow the grinding drum to reach full speed before
starting work.
- Only process wood that has as few knots as pos-
sible.
- Make sure that the workpiece is free of nails,
screws or other foreign bodies that could damage
the grinding drum or the feed belt.
- Use only original spare parts and accessories.