Holzstar ZSM 560, Instruction Manual

Page: 19 / 32

Care, maintenance and repair
ZSM 560 | Version 1.01 19
Step 5: Make several light sanding passes without turning
or flipping the board.
Step 6 : Remove the workpiece and switch off the machine.
Step 7: Perform measurement at location A and B as
shown in Figure 25..
- If dimension "A" is less than "B", loosen or remove
the screws on the right hinge support. Remove or
place a washer between the support and the frame
to compensate for the difference between "A" and
"B.
- If dimension "B" is less than "A", loosen or remove
the screws on the left hinge support. Remove or
place a washer between the support and the frame
to compensate for the difference.
Fig. 25: Set parallelism of feed belt to grinding drum
Step 8: Repeat steps 1-5 to verify adjustment. If neces-
sary, repeat step 5 until the parallelism of the
feed belt and grinding drum is within 0.05" from
side to side.
14 Care, maintenance and repair
14.1 Cleaning
Step 1: Disconnect the power plug from the socket.
Step 2: Empty and clean the suction device.
Step 3: Clean the machine of sawdust and sawdust.
Step 4: Check fastening screws and safety devices for
tightness and tighten them.
Step 5: Thoroughly clean resin deposits on the machine
using resin remover.
Step 6: Spray all unpainted metal surfaces with some
anti-rust spray.
Step 7: Inspect the machine for damage to safety de-
vices and the sanding belt. If necessary, carry
out the repair or arrange for it to be carried out,
observing the safety instructions..
14.2 Regular check and maintenance
Lubrication of the machine
Regularly check the grinding belt for defects.
1. Replace a damaged grinding belt immediately. Check
the correct setting of the feed belt at regular intervals.
Lubricate monthly all moving parts (Fig.26) such as
threaded spindle, pulleys and bearing bushes inclu-
ding the height stop, sliding surfaces and bushes
connected to the height adjustment mechanism. Do
not use oil or grease for this purpose as it tends to bind
sawdust.
DANGER!
Danger to live due to electrical
voltage!
Contact with live components can be fatal. Activated
electrical components can execute uncontrolled mo-
vements and cause serious injuries.
- Switch off the machine before carrying out cleaning
and maintenance work and unplug the power cord.
- Connections and repairs of electrical equipment
may only be performed by a qualified electrician.
Left Right
bracket bracket
Wear safety gloves!
Wear protective clothing!
NOTE!
Never use harsh cleaning agents for cleaning. This
can lead to damage or destruction of the device.
Provide adequate ventilation when using solvents.