Holzstar ZSM 560, Instruction Manual

Page: 10 / 32

10 ZSM 560 | Version 1.01
Description of the device
8 Description of the device
Illustrations in these operating instructions may de-
viate from the original
Fig. 3: Cylinder Sanding Machine ZSM 560
A Machine base
B Feet
C Feed belt
D Extension table
E Grinding roller cover
F Handwheel for height adjustment
G Motor
H Feed belt drive
I On / Off switch
J Feed controller
8.1 Space requirement
Fig. 4: Space requirement
9 Set up and connection
9.1 Requirements for the installation
site
The cylindrical grinding machine must be set up on a le-
vel and solid surface in a stable manner. It must be ensu-
red that there is sufficient freedom of movement for wor-
king. There must be at least 1 m clearance from the wall
to the Cylinder Sanding Machine on each side. The in-
stallation site should meet the following criteria:
- The substrate must be level, firm and vibration-
free.
- The surface must not allow any lubricants to pass
through.
- The installation or work area must be dry and well
ventilated.
- No machines causing dust and chips should be
operated in the vicinity of the machine.
- There must be sufficient space for the operating
personnel, for material transport and for setting
and maintenance work.
- The installation site must have good lighting.
10
Setting up the Cylinder Sanding
Machine
Wear safety shoes!
Wear protective gloves!
CAUTION!
Risk of injury due to an unstable machine!
Check the stability of the machine after setting it up on
a stable surface.
CAUTION!
Observe the weight of the machine!
The machine may only be set up by two persons to-
gether.
Check the auxiliary equipment for sufficient dimensio-
ning and load-bearing capacity.