ASSEMBLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
24
BT 1220TOP
12.2
Machine to stand
The machine is supplied with 4 rubber feet, which can be mounted to protect the working surface.
Tilt the sander up and slide the feet onto each of the four
corners of the sander.
Then fix the machine with the 4 screws (7) and washers (8) on
both sides and nut (9) on the assembled stand.
12.3
Sanding table / fence
12.3.1
Assembly on Disc-Sander
The metal Sanding Disc is pre-installed on the
machine and also the sanding Abrasive Disc (Grain
80).
The larger worktable is used with the sanding disc.
It should be used to support workpieces in all
sanding operations except inside curve applications.
Place the worktable onto the sander frame, aligning
the semi-circle slot with the threaded hole. Place a
washer on threaded shaft of each worktable handle,
insert through semi-circular slot, and tighten into
threaded hole. Repeat on other side of table.
12.3.2
Assembly on belt-Sander
12.4
Installing dust collection
The use of a dust collection system with the sander is strongly recommended.
The sander has one dust ports (Slide the hose of your dust collector over the outlet, and secure
with a hose clamp (not in the delivery content). Outer Diameter of port is ø50mm.
The sander includes 2 fences for use with the sanding belt. The
small Fence/Platen (Part #56) attaches directly to the sanding
Belt Frame (#52), and is used for supporting small items being
sanded.
The larger Fence/Platen (#55) attaches onto the small fence. It
gives a larger support surface for sanding large work pieces.
NOTE: These parts may be pre-assembled at the time of delivery.
If not, follow the following parts assembly:
1. Install the small Fence onto the sanding Belt Frame with the 4
Hex Screws and washers (#27, 58).
2. Insert two star-head Screws (#54) through the countersunk
holes in the large Fence and install the Knobs (#57) on their
threaded ends.
3. Slide the large fence’s 2 screws with knobs over the two slots
in the small fence and fasten in place.
Pending on the material being sanded, the large fence
can easily be removed by just loosening the two knobs
and sliding it off the small fence.
Attention! To prevent fingers from being squeezed
between the band and fence a minimum separation of
1.6 mm has to be maintained between the fence and
Sanding band.
Summary of Contents for BT 1220TOP
Page 66: ......
