APPLIANCES — 4
94
2008 IMPERIAL
Filter Replacement:
The
fi
lter should
be replaced every
twelve months. The
fi
lter may need to be
changed more often
depending on use
and water quality.
Observe
fi
lter status
on the interior
refrigerator control panel.
CAUTION:
Air trapped in system may cause water
and cartridge to eject. Always dispense
water for at least two minutes before
removing the filter for any reason. Use
caution when removing.
WATER DISPENSER - HOT (Optional)
The Insta Hot system
includes a stainless steel
reservoir, a 120 Volt AC
heating element and a
dispenser at the galley
sink.
CAUTION:
Steam or hot water
may spurt from
the faucet without
turning it on.
WARNING:
To minimize the possibility of fire, DO
NOT store flammable items such as
rags, paper or aerosol cans near the
mounted tank under the galley sink.
DO NOT store or use gasoline or other
flammable vapors and liquids in the
vicinity of this unit.
NOTE:
Water boils at lower temperatures in
higher altitudes. It may be necessary
to lower the thermostat setting when
operating the Insta Hot at higher
altitudes to prevent water from boiling.
Operation:
Hook to shore power, start the generator
or turn on the inverter.
Ensure adequate water supply for the
Insta Hot from the fresh water tank or
city water connection.
Press the Insta Hot switch
located at a galley cabinet
switch panel to turn on the
heating element.
Depress the hot water handle
until water runs from faucet
to ensure the system is full of
water.
Water will reach target temperature in
approximately 12 to 15 minutes. Gurgling
or hissing is normal during start up.
WARNING:
The faucet dispenses water at
temperatures up to 210º F. This can
cause instant scalds or burns. Use care
when operating this appliance.
Thermostat Factory Setting:
Factory temperature is preset to 200º F.
To reset the thermostat to 200º F., align the
indicator notch on the thermostat dial one notch
to the right of vertical.
Thermostat Adjustment:
Turn the thermostat dial on the front
of the tank clockwise to increase
temperature or counterclockwise to
decrease temperature.
After adjusting,
depress the hot
water handle and
let water
fl
ow for
20 seconds.
Repeat if
necessary. All
changes should be
minimal.
CAUTION:
DO NOT allow
the water to boil.
Cleaning Hot Water Dispenser:
Use only mild cleaners to clean the dispenser
spout and plastic components. Use of cleaning
agents containing acids, alkaline or organic
solvents will result in deterioration of plastic
components.
031254b
Filter Housing
060297d
INSTA
HOT
Located on
the galley
switch panel.
040490
040490
